Dongguan Dezhijian Plastic Electronic Ltd
Dongguan Dezhijian Plastic Electronic Ltd
Add to Cart
Clear 3d printer filament pla 1.75 mm recycled high temp High toughness Filament
Filament PLA 13 Colors 3D Filament 1KG 1.75mm Plastic Consumables Material 3D Printer Filament 3D Pen
HS-PLA 3D printer filaments information:
HS-PLA is biodegradable and made from materials such as corn starch, tapioca roots, and sugarcane. As one of the most popular 3D printing filaments now. HS PLA is a multiple purpose material with high strength and minimal warping. HS-PLA's impact resistance data is 42KJ / ㎡.4-5 times that of general PLA. HS-PLA 's tensile strength is 72M pa, which is 1.5 times that of generalPLA. HS-PLA's elongation at break is 45%, which is 10 times that of general PLA.
The raw materials have been modified, and the HS-PLA 3D filament have been tested and can withstand the high temperature of 75 ° C in the oven without deformation, which is approximately equal to the heating temperature of the floor plate at 95-105 ° C under outdoor conditions.
Parameter
| Filament Diameter | 1.75/mm |
| Tolerance | ±0.03mm |
| Print Temp | 240—260℃ |
| Bed Temp | 60—70℃ |
| Bed Setting | Masking tap or temperature resistant heat tape |
| Applicable Models | FDM—3D Printer |
Product Advantage:
PLA, polylacticacid, is a new biodegradable and environmentally material.The printing temperature is generally between 180-210℃, and no pungent smell when printing .It has a good anti-solvent type, good biocompatibility, gloss, transparency and heat resistance.
Quality control:
1. All of our 3D printer filaments are 100% virgin material,never use recycled material or regrind material,and all had achieved the latest certificate.
2. Before the mass production,our engineer always do the test to make sure that each batch of new raw materials must be printed by 3D printer.
3. The Laser diameter runs automatically to control the diameter of the filaments and keeps it in a right range of 1.75/3.0mm,and our engineer will adjust it immediately when it alarms to indicate of wrong size,and this unqualified filament will be cut off and never use it.
4. To keep the filaments dry,each roll of filament is packed in a vacuumed polybag with a desiccant inside of it.