Dongguan Dezhijian Plastic Electronic Ltd
Dongguan Dezhijian Plastic Electronic Ltd
Add to Cart
3d printer filament PLA ABS filament 1.75mm 1kg 5kg 0.5kg for 3d printing
Filament Introduction :
| Name | PLA |
| specification | 1.75mm 3.0mm |
| Net weight | 1.0kg |
| Gross weight | 1.3kg |
| Printing temperature | 200°C -240°C |
| Floor temperature | 100-120°C |
Product Description
PLA melts at a relatively low temperature of about 175 degrees Celsius. Unlike so-called thermoset materials, PLA can be heated past its melting point multiple times with very little degradation. It’s a hard material, but that also means it’s somewhat brittle, and once it breaks, it likes to shatter.
The best use of PLA is for printing concept models, prototypes, miniatures, jewelry, low-wear toys, etc.
Product Feature
1). Good toughness,High strength, High stiffness
2). No block nozzle, Good stick hot bed
3). Cost-effective can be processed in wide range temperature;
4). Low shrinkage, thermoforming dimensional stability
5). Accurate diameter: 3.0/1.75mm, variations + /-0.1mm,roundness +/-0.05mm;
6). Suitable for a variety of 3D printer, Makerbot, UP, Cubify, Leapfrog, Reprap, Ultimaker, Mendel, Prusa, Huxley etc.
Product Information
| PLA Filament | |||
| Filament Diameter: | 1.75/3.00mm | ||
| Tolerance: | ±0.03mm | ||
| Print Temp: | 190-210℃ | ||
| Bed Temp: | Optional or 40-60℃ | ||
| Print Speed: | 40-100mm/s | ||
| Bed Setting: | Masking tap or temperature resistant heat tape | ||
| Applicable Models | FDM-3D Printer | ||
Product Advantage
1. Material: Raw materials are all imported from the United State, there’s absolutely no defective, recyled raw materials or in it.
2. Weight: The net weight of Consumables is 1kg, component fully.
3. Appearance: support custom.
4. Repeated Teat Results:Compared with ordinary low consumables on the market, this material toughness stength, higther hardness, printing support artfifacts more easily removed.